If you design wrought ironwork, hammered period steel Craft or smelted and moulded grindstone, metal Craft is a satisfying behaviour to certain yourself.
You Testament extremity to memorize to solder, weld and genuine and safely account a propane torch, forge tools, bench and right-angle grinders and differing metalworking plam tools before you construct metal Craft.
Grip inspiration from the anticipated apple, works of fiction and fantasy or the job of noted artists throughout the ages. Basic guideline of plot such as balance, proportion, rhythm, accent and confederation benefit you create metal Craft with maximum visual crash.
Instructions
Hammer thin sheet steel and rod stock cold. You may have to heat thicker steel before working it. Use standard soldering techniques to secure small design elements to each other.7. Decide if to make single-element metal art or a multiple-element scene.
2. Sketch your chosen design elements onto a large sheet of poster board. Transfer your design elements onto clear overhead projection sheets if you want to increase or decrease their sizes. Reposition the various elements until the overall design pleases your eye.
3. Transfer your sketched elements directly to 24- or 14-gauge sheet steel or steel plate, or cut out your poster board shapes, lay them on the steel and sketch around them with a black permanent marker. Do not overlap any design elements at this stage.
4. Don wrap-around eye protection before you cut all the design elements from your sheet steel or steel plate using center-cutting metal shears or a cutting wheel on a 4-inch right-angle grinder, depending on the gauge, or thickness, of the steel.
5. Remove burrs with a bench grinder, using a fine-grinding wheel and a wire wheel.
6. Smith the steel to shape by hammering and bending it as needed.1. Double o sorrounding for inspiration. Notice the shapes and textures in your congenital universe.
Don a welding helmet, gloves and full leathers. Weld medium and large elements to ensure a secure hold, using a 110 gasless MIG or other welder.
8. Arrange all design elements as desired, overlapping elements as needed. Solder or weld all pieces. Drill screw or bolt holes where necessary. Add any loops or hangers.
9. Finish-grind and wire-wheel your project as desired to supply a brushed finish down To cleanse steel. Add patina or paint if desired, before you apply clear spray enamel to protect your finish.
