Many blend engineers choose to cover analog devices into their ProTools setups.3. Now check that the analog compressor is in bypass put powered on. Open the Signal Generator plug-in and lower it to 100Hz. Click the red "target" button at the top right corner of the plug-in to keep it visible, while you then open the Paz Meter.
For this case I Testament be setting up a stereo analog compressor for insertion on the crack buss.
Instructions
1. When applying a stereo analog compressor it is public to calibrate the levels to clinch Correct balance of the stereo dead ringer.
We Testament anterior commence by creating a stereo crackerjack fader and one stereo audio track. On the master buss the fader is created with a default setting of 0dbFS. Freedom it there.
Incorporate the analog compressor to that buss. Momentarily embrace the Waves Paz Metre after the compressor. Set the Paz Meter to the fastest resolution (50). Leave it flat and to react to peaks.
2. On the audio track ensure that it too is at the same level (odbFS). Insert the stock Digidesign Signal Generator to this track.
Make sure that the speaker volume is down low to avoid any loud bursts of noise, as this can damage your speakers.
The chain reaction is oftentimes preferred over the keepin the compound all in-the-box. This allows for a enhanced hybrid drawing near to mixing and thus furthers the evolution of the current digital audio workstation.I Testament present you accurately place up the Accoutrement with a effortless calibration means.
You'll want to check the meters at different frequencies to ensure that it is operating consistently. I typically begin with 100Hz, 1kHz and 10kHz.
4. Once you have determined that all is well you can now continue with your session.
