Pleasant indie films and capacious budget blockbusters all rely on one affair to hand the movie satisfy popular into the mainstream fold--lighting. It sounds child's play Sufficiently on the contrary lighting creates tenor and visually enhances a scene on the contrary you can't government habitual ablaze. You can, on the contrary, actualize your own. Indoor lighting is tricky and the capital doable impression is to block window luminosity from entering your scene to deed you plentiful authority of daylight also as the midnight. If you want to join the ranks of the pros, read on to memorize more about block window light when shooting a film.
Instructions
1. Look where you are shooting and examine the scene. Pull out your cardboard and refer to your list of measurements.4. Using the measurements of the windows begin drawing them onto the cardboard but adding 2 inches to each side extremely as top and bottom.
Determine what windows will be throwing light into your scene.2. Use your measuring tape and take measurements of the window lengths and widths making sure to write them down as windows may be different sizes.3.
5. Cut out the cardboard along your lines.
6. Cover the cardboard with the spray paint and allow to dry completely.
7. Line the cardboard up with the window so that the two inches can be visibly seen around the entire window.
8. Using duct tape begin taping the cardboard to the surrounding wall by keeping half the tape on the cardboard and half the tape on the wall.
9. Add a second layer of duct tape so that half the tape is overlapping the wall edge of the previous used duct tape and the other half is on the wall.
10. Repeat Step 9 but on the inside edge of the cardboard.
