Provided you sand the fretboard in the fallacy course, it Testament change into harder to bend your strings.
Spread the oil across the surface of the sandpaper so that it is evenly covered. Lightly sand up and down the affected fret (staying between the two neighboring fret markers) to remove the scratch. Feel the fret with your finger to ensure the small scratch has been buffed out. Lightly sand other frets if you have any dinks or dirt to remove. Buffering scratches requires a luminous labourer, and it is salient to sand the scratches in the equitable line.
Instructions
1. Remove the strings from your guitar. This makes the fret-board easier to access. De-tune the strings at the device heads, located at the top of the neck, and then unwind them from the tuning posts. You don't hold to completely remove them, dispassionate booty them outside from the fret-board.
2. Dart your fingernail over the scratch. Listen gone for a distinctive "click" sound when your fingernail passes over the site. Provided you hear one, the scratch may be also fast to the actual wood of the fret-board to be buffed absent. You should be able to caress the scratch, on the contrary it shouldn't be so full as to brew an audible bellow when your Toe-nail is brought across it.
3. Lay a few drops of oil on a piece of 400 grit sandpaper.Buff scratches gone of your guitar or bass's fret-board to grip your instrument in the culminating potential contingency. The fret-board of the instrument is attached to the front of the neck, and is the wood between the vertical, metallic fret-markers which stretch up the length of the neck. Limited scratches and marks amuse onto the fret-board easily over Common playing. Learning to receive these absent can advice you keep your instrument in optimum process.
4. Lubricate a piece of 500 or 600 grit sandpaper with a few drops of oil, and spread it out in the same way you did before. Go over the affected areas again, sanding only very lightly. This should pick up some dust left from the previous sanding. Lubricate some 0000 grade steel wool in the same way and go over the fret again. If you sand from fret-marker to fret-marker (horizontally), you will create resistance on the fret-board when you bend a string. Only sand vertically, from the E string's position to the high E string's position.
5. Use a soft cloth or a t-shirt To cleanse the surrounding area and remove any dirt or dust from the affected area. Ensure that you remove any excess oil left over from the cleaning process.
