Friday, October 23, 2015

Motorcycle Painting Techniques

Motorcycles are still smaller than cars and bear less surface areas to emulsion. Spray the parts with three or four thin coats of paint. Allow each coat to dry for 30 to 60 minutes before applying the next coat. Once the paint has dried for an hour, spray the parts with four thin layers of clearcoat paint.

When choosing tint for your motorcycle, conserve in attitude the delineation you demand to adoption. Speciality paints commensurate chameleon colours, chrome dye, glow-in-the-dark distemper, prism distemper and other expensive paints can be used to devise a correct single and one-of-a-kind custom emulsion berth on your motorcycle. These paints can be used by themselves or on top of a common imitation coat of emulsion.

After choosing the gloss for your motorcycle, get the primer, clearcoat paint and reducer to go with it. All of these materials should be made from the same manufacturer, not mixed with any other company's products. Mixing brands could possibly cause unwanted chemical reactions and imperfections in the paint's finish.

Prepping the Motorcycle

When painting an entire motorcycle, remove the parts that will be painted. If this is not possible, remove or cover surrounding parts that won't be painted. Use masking tape and paper to completely seal these parts so overspray from the paint can't reach them.

Use 120 grit sandpaper to sand the old paint and primer off of the motorcycle. A dual action sander may be used, but some areas must be sanded by hand because of the angles and size of the parts. Wipe the sanded areas with wax and grease remover and a microfiber cloth. Spray two thin coats of primer on the sanded areas, allowing each coat to dry for thirty minutes before applying the next. Once the primer is dry, sand it smooth with 300 grit sandpaper. Wipe the area several more times with wax and grease remover.


Wipe the areas covered in primer with a tack rag to pick up and remaining particles of dust or dirt. This mode amassed epoch can be place into the emulsion engagement and choice standard whitewash can be used on a motorcycle. There are many stain companies that rendition especial paints, on the other hand are expensive and also costly to manipulate on bulky vehicles.

Choosing Paint

Allow the paint to dry for a full Day and night before touching or moving the parts. Wait two full days before putting the parts back together if they were taken off of the motorcycle.