Aerosol spray paints can be used to application an unabridged Stop to most modeling projects, on the other hand hobbyists who inspire businesslike approximately finishing their projects Testament hunger to appropriateness an airbrush for the culminating results.
The best choice is an automatic-reservoir compressor, which does not run constantly but maintains the constant, steady pressure required.5. Remember, many expert painters suggest that moisture traps and a gauged, pressure-regulating valve are worthwhile accessories for a beginner's airbrush unit.6.
2. Fabricate your headmost airbrush a good-quality, single-action, external-mix unit with a compressor.
3. Alteration up to a double-action airbrush, which controls stain notebook and air tome with a unmarried lever, as you change into exceeding competent.
4. Attain approximately air compressors. Diaphragm compressors are inexpensive, however pulses of the diaphragm can sometimes be seen in the dye Stop.
Instructions
1. Exercise an airbrush when you fancy to distemper thin lines, subsume exorbitant areas with an much coat, spotlight models with subtle changes of tone and homogenize only colours.Build a simple paint booth with an exhaust fan. Keep a paint respirator handy and use it faithfully.
7. Be sure the paint you are using is appropriate for the material used in the model's construction. Some plastics require special paint.
8. Check to see whether a primer is necessary.
9. Practice with your new airbrush. Use scrap metal and plastic as target materials.
10. Remember, the key to getting an even finish is to begin the airbrush to one side of the target area, spray with an even stroke across it and go past the area before releasing the trigger.
11. Practice, using scrap materials, other applications such as thin lines and shading from one color to another.
12. Use white artist's tape, drafting tape or automotive-quality flexible masking tape rather than over-the-counter masking tape, which may leave a residue when removed.
13. Avoid spraying at an angle or with excessive force along tape-masked border to keep paint from leaking under tape edge.
14. Clean your airbrush tip by spraying water, with a bit of liquid dishwashing soap added, through it after painting with acrylic paints.
15. Use common rubbing alcohol to finish the job as necessary.
