Hook Up 6X9 Neon Ablaze Call Speaker Boxes
Conventional speaker boxes are charming elementary to hook up. They lone hope for a speaker wire connexion from the receiver or amplifier that Testament be powering the speakers. Neon flare telephone speaker boxes add another requirement--the require for function. The neon lighting in the boxes requires a 12-volt DC faculty input for blaze, the twin as remainder of your car-audio development. Ideally the potency work Testament be place up to automatically come on when the stereo is in transaction. You can achieve this by tapping into the equitable wires of your motorcar stereo.
Instructions
1. Chop two lengths of 16-gauge insulated wire, one nigrescent and one bloodshot. Everyone should be extensive Sufficiently to arrive from the site of the speaker box to the back of your motorcar stereo. Remove approximately a half-inch of insulation from the ends of Everyone portion of wire.
2. Loosen the energy and ground terminals on the back of the speaker box. These will be screw terminals, marked "PWR" and "GND." Slide the bare end of the red wire into the power terminal and tighten the screw to hold the wire. Twist together the ends of the red wire coming from the box and the blue wire, and wrap electrical tape around the joint to cover any bare wire.4. Strip about a half-inch of insulation from the black wire on the back of your car stereo.
Slide the end of the black wire into the ground terminal and tighten the screw to hold the wire.3. Strip about a half-inch of insulation from the blue wire on the back of your car stereo.
Twist together the ends of this wire and the black wire coming from the box and wrap electrical tape around the joint, covering any bare wire.
5. Press down on the red speaker terminal on the back of the speaker box. The terminals are marked "SPKR." Slide the end of the speaker wire marked with a series of "+" marks into the terminals and release the terminal to clamp the wire.
6. Press down on the black speaker terminal on the back of the speaker box. Slide the end of the speaker wire marked with a series of "-" marks into the terminals and release the terminal to clamp the wire.
