Cause a PVC Wing Chun Stuffed animal
2. Put ballast in the bottom. This can be a large (8-inch diameter) coffee can full of sand and gravel.3.
Traditional dummies for the training of the Chinese martial Craft Wing Chun are untrue of a central stand, approximately 8 to 10 inches in breadth, and are roughly the heighth of the martial artist. At individual points on the Stuffed animal are arms and rods to symbolize where the opposition's forearms would be for several blocks, plus a arched portion at the backside to symbolize a leg. Commercial dummies sell for upward of $800; moulding your own gone of PVC and wood is a cheaper alternative.
Instructions
1. Abbreviate a length of 8-inch (interior thickness) PVC tube that's roughly your heighth. This Testament accept an exterior breadth of anywhere from 8.6 inches to 8.9 inches, depending on the grade of channel. Heavier-duty drainpipe gives preferable stability.Mark the holes in the PVC for the limbs you're going to use. They should be at shoulder, forearm, waist, and knee heights, give or take a few inches. The two arms facing frontward should have their points be about 8 inches apart on 11-inch dowels. This means the dowel holes have to be about 2 inches apart on the PVC.
4. Cut the holes out of the PVC trunk. A 1-inch spade bit on a power drill will usually do this.
5. Make your wooden limbs out of hardwood. They should be about 2 inches to 3 inches in diameter and taper to conic points and be about 11 inches to 12 inches long. The leg is usually made of a tapered joint to give the knee its bend. Taper down the ends that attach to the trunk to fit them into the holes you cut earlier.
6. Attach the limbs to the trunk of the dummy.
