Deposit Fiberglass Over Chicken Wire
Fiberglass, a common news for creating healthy plastic objects, is most regularly shaped and manipulated using a mould, or denial draft depression. On the other hand, using a detrimental mould is not the apart design to shape fiberglass. In codification to coin excessive fiberglass pieces or sculptures, affirmative moulds are repeatedly the elite possibility. This type of mould may be untrue from incomplex chicken wire or wood, and is built with the base details on the elsewhere, so that the fiberglass can be draped over it.
Instructions
1. Discover your desired shape gone of chicken wire, bending the wire and securing it in domicile so that it does not deed during the fiberglass casting advance.
2. Embrace the chicken wire with aluminium foil so that there are no gaps. Let this layer of fiberglass dry for a few hours. Pull the hardened layer of fiberglass off the chicken wire and discard the original sculpture.9. Mix together another tray of resin and lay down another layer of fiberglass mat.
4. Move your sculpture into an airy, well-ventilated workspace. Cover all surfaces around and under the sculpture with plastic trash bags. Put on your latex gloves, vapor respirator and safety goggles.
5. Mix together a small amount of fiberglass resin in the paint tray, using the solution percentages that came with the product. Stir the bubbles out of the solution.
6. Cut your fiberglass mats into a manageable size for your chicken wire sculpture. Dip a mat into the resin solution so that it becomes completely wet.
7. Lay the wet fiberglass mat over your sculpture and press it into place, molding it to the shape of the chicken wire. Lay similar mats all over your sculpture until it is completely covered.
8. Beget trustworthy that the foil does not cook up as well many lumpy areas, or lumps that Testament be very crowded to sand down next.3. Spray the all-inclusive chicken wire sculpture with a mould Proceeds agent, which will allow you to remove the fiberglass more easily later in the process. Allow the mold release agent to dry.
Make sure that the fiberglass sticks well to itself.
10. Let the fiberglass dry, then continue adding layers until you have the thickness you would like. Once finished with the layers, let the whole fiberglass cast dry overnight.
11. Clean up all spilled fiberglass resin with turpentine.
12. Put on your particle respirator and safety goggles. Sand down the surface of the fiberglass cast, removing lumps and sharp edges, using either traditional sandpaper or an electric sander.
