The delineation is viewed complete the window in the matte board.
A matte, too spelled matt or mat, is a decorative contour that goes all over a delineation. When framing canvas paintings, you should applicability acid-free matte board to avoid poor the artwork. You can incision matte board Homewards with a Art point and secure it and the picture to a frame with counterbalance clips. When framing a canvas depiciton, you single essential the front detail of the frame and glass is not required.
Instructions
Cut the Matte Board
1. Degree the picture with a ruler.
2. Assign the matte board on a adamantine, Apartment lodgings surface with the back of the board facing you. Appliance a board that's 1 inch wider and longer than the picture.
3. Haul a square or rectangle in the centre of the board using a pencil and ruler. The heighth and wideness of the square or rectangle should be less than the heighth and breadth of the delineation. This is the window the delineation shows completed.
4. Affiliate the ruler with one of the window's edges, and shorten along the contour with a sharp Art edge. When cutting, dominion the Art bait chopper with the blade pointing straight down. Decrease along Everyone contour in the alike way.
5. Push away the inside lot of the matte board gently. Allot the inside portion aside.
Frame the Painting
6. Remove the backing and glass from the frame, if necessary.
7. Place the frame on a hard, flat surface with the back of the frame facing you.
14. Use a screwdriver to drive the screws through the matte board and frame. Depending on the thickness of the matte board, you might need longer screws than those provided with the offset clips.
Tape the corners of the matte board to the back of the frame with masking tape to prevent it from moving.
10. Place the painting on top of the matte board, and center it inside the frame and matte board.
11. Place an offset clip 1 to 2 inches from the bottom left corner of the canvas and another 1 to 2 inches from the bottom right corner. The side of the clip containing a hole rests against the matte board and the other side rests against the canvas stretcher bar.
12. Place an offset clip 1 to 2 inches from the top left corner of the canvas and another 1 to 2 inches from the top right corner. The side of the clip containing a hole rests against the matte board and the other side rests against the canvas stretcher bar.
13. Place screws in each of the offset clips.
8. Place the cut matte board on top of the frame with its back facing you. Center the matte board over the frame's opening.9. If you're using longer screws, they must be shorter than the total thickness of the matte board and the frame when they're added together.
