Dream up your own dragon sketch for a silver necklace.
Carving a silver dragon pendant is a entangled means that involves specialized Accoutrement. Silver is not carved directly; instead, the carving is done in a certain type of widen. This develop is then prepared and assign into a mold--a system called investment--then the widen is melted elsewhere, normally with a steam dewaxing computer. A centrifugal casting pc is used to inject silver into the mould. The silver dragon figure is then removed from the mould and the group is cleaned and finished.
Instructions
The result is the amount of silver you will need to melt.5. Attach the sprue to the bottom of your casting flask with sticky wax or the container's built-in attachments, if it has them, leaving approximately equal space approximately your wax dragon model. Mix enough plaster of Paris to fill your flask, carefully breaking up any lumps, then pour the mixture into your flask. You can pattern your dragon based on traditional styles, such as Chinese dragons, which little keep wings and tend to facet dog or lion-like faces, or choose a expanded contemporary fantasy style of dragon that is bounteous serpentine. Practice a benumbed factor to gain a rougher texture for the scales and a glowing part to accomplish a smooth texture for the claws. Practise definite all of the fact you wish in the finished dragon is commenced in the broaden.
2. Decide which chip of your dragon you requirement to manipulate for the necklace attachment, such as the arch of the back or a wing that is raised overhead. Accomplish certain there is a Apartment lodgings surface on account of globe broad Sufficiently to drill a 1/16-in gap through, while leaving at least 1/16 inch of silver between the hole and the edge.
3. Create a sprue out of sprue wax and melt sticky wax to attach the sprue to a part of your dragon with the lease amount of detail, such as its chest or haunch. The sprue is a rod that will, when melted, allow the silver to enter your dragon mold.
4. Weigh your model to the nearest ounce and multiply the weight by 10.4.1. Carve your dragon outside of jeweller's broaden with broaden carving tools. You may avail the benign of carving tools that are electrically heated or you may heat them manually with an exposed flame as needed to chop wound up the develop. Recompense characteristic care to areas of great feature on your dragon, such as teeth, scales, wings and a tail.
6. Place the casting flask on the vacuum table and close the lid. Turn on the table and allow it to vibrate the air out of the mold for the amount of time specified in your user's guide.
7. Place the flask in a steam dewaxer to remove the wax. This will also heat the mold, which is necessary for a smooth cast. Place the silver casting shot in a crucible in the furnace and turn it on to the recommended setting for silver, per the manufacturer's instructions.
8. Place the flask and crucible into the appropriate spots on the centrifuge and operate the centrifuge according to the manufacturer's instructions for casting silver.
9. Let your silver dragon pendant cool and harden for about 2 hours, then remove the plaster from the flask and break it open with a mallet. Clean off any remaining plaster, using a toothbrush and warm water to scrub textured surfaces such as your dragon's scales and between its toes.
10. Cut off the sprue with a multitool, then use the tool's grinding attachments to remove remainder of the sprue.
11. Drill a hole in your designated spot on your dragon, using a drill press to keep the hole straight and a 1/16-inch drill bit. Grind away any residual silver around the hole, then use your multitool's buffing attachment and a buffing compound such as red rouge to polish the dragon pendant.
12. Spread the prongs of a necklace bail with pliers, then firmly pinch it together so the prongs at the front and back rest firmly inside the hole at the top of your pendant. String the chain or cord of your choice through the bail and your silver dragon pendant will be ready to wear.
