Canvas storage racks are a necessity for protecting Dainty canvas frames and the works of Craft mythical on them. Storage racks for canvases dispense a guarded country for wet canvases to dry also as offering a design to store finished works to conserve them gone of a cluttered studio where they may metamorphose damaged. A framework is child's play To erect with some lumber and can be kept in any direction with a controlled area, such as a finished basement.
Instructions
1. Dispose how high the structure Testament be. This is based on the vastness of the space that the shelf Testament be stored in and how many canvases Testament be stored. Artists can accumulate many canvases over the age that Testament compulsion to be stored safely, so better is higher quality.
2. Decide how lofty and Broad the stand should be based on the dimensions of canvas normally trumped-up. Bring ample heighth and wideness to protect sizeable canvases four or another feet hovering or wide.
3. Cut two 2x4 pieces to fit on top of the bottom rectangle support. Lay the widest side of the 2x4 flush to the rectangle and pressed against the vertical supports. Attach the 2x4 with wood screws and glue to the bottom rectangle. Do this for both sides.
The back of the rack will be placed along the wall, the sides will come perpendicular to the wall, and the front will be left open to place the canvases inside. Use a hand drill to make pilot holes, and then attach the wood pieces with wood glue and wood screws.
5. Cut four 2x4s to the height measurement from step 2 to create the vertical supports, one in each corner of the rectangle. Place the widest side of the 2x4 flush against the side of the rectangle, make pilot holes with a drill and attach with wood glue and wood screws. Continue this for the remaining corners.
6. Measure the distance between the vertical supports in one corner. Cut a 2x4 and attach it between the two vertical supports. Do the same for the opposite side.
7. Cut two 2x4 lumber pieces to the length measurement from step 1, and two 2x4 pieces to the width measurement from step 2.4. The bottom support is a rectangle that will sit on the floor.
8. Continue steps 5 through 7 until all the space is used inside the rectangle.
9. Measure the distance from the first vertical support to the last. Cut a 2x4 support beam and attach it to the vertical supports at the top back of the rack.
