Monitors are cardinal for hearing yourself on event.
Route an area that will fit the speaker jack. Use the best material you can afford and glue it together to hold the wood in place. Nail it after the glue has dried for extra stability.
Design
1. Formulate the configuration and type of phase monitors you Testament charge. Side fills are used for the side of the page and call for favorable dispersion, as they Testament be relatively far outside from the musicians. Floor wedges are used primarily for the front of the chapter and are aimed upwards, so the depiction must subsume this specific Line.
2. Design the placement of the speakers very as the types of monitors you Testament account onstage. Small stages need smaller speakers, so you can use small floor wedges such as a 10-inch or 12-inch full range woofer too as a tweeter. Side fills may need dual 15-inch speakers and a high-frequency horn. The configuration you use must be appropriate for your stage size.
3. Choose the material you will use further as the brand of speakers to use. Celestion speakers are very common and are priced well relative to their quality. They make low-weight neodymium speakers very as those with traditional construction. Choose MDF or a sturdier type of wood for the cabinets to save money and possibly weight if the monitors will be moved often.
Construction
4. Build the main cabinet of the monitor. (See Reference) This includes the top, bottom, back and sides.When designing and building your own leaf monitors, it is capital to deliberate the folio you Testament using them on also as the types and sizes of speakers you Testament using in your venue. Provided you hold a rock club, heavier duty speakers may be crucial. For jazz and other mellow types of ragtime, too as plays and other theatrical endeavors, lighter speakers may be aggrandized than Sufficiently, as they can save you bill you could settle toward other projects.
Instructions
5. Route the front piece for the speakers, including the tweeter or horn. Trace the templates for the speakers and drill a hole within the tracing. Place the jigsaw in the hole and cut the speaker hole out. Place the speakers in the front baffle and screw them into the wood. Wire the speakers with enough slack for the speaker jack, which will be attached to the back of the cabinet.
6. Glue and nail the front piece onto the cabinet, making sure the wires are inside. Pull the wires through the speaker jack hole in the back of the cabinet. Screw the speaker jack into place.
