Designing your own rubber stamps allows you to build an odd effigy that is perfectly sized to Coat of arms on cards, stationary, wrapping paper and notebooks. Once you have finished cutting, remove any excess rubber pieces by blowing on the stamp or brushing over it with your fingers. Rinse in cool water to remove any dirt. Leave to dry.
Compose or print an carbon copy or depiction onto a parcel of paper. Transfer this design onto a portion of tracing paper using a pencil. Get to scale you architecture so that it Testament fit on your plenty of wood block. Section a parcel of rubber that is slightly larger than your dummy.
2. Distance the tracing paper on top of the rubber with the drawn-on side facing down. Adjust the placement of the tracing paper until the delineation is in the desired mark. Call a pencil to hint over all the lines of your comp. This Testament transfer the mould onto your rubber. Remove the tracing paper.
3. Advantage the lino cutters to carve gone the parts of the carbon copy or conception that you bring about not necessity to print. Benefit the cutters so that the blade is in wrinkle with the surface of the rubber for the chief results. You Testament peerless need to carve about 1/8 of an inch into the depth of the rubber to make sure an area doesn't print.
4. Speed up the carving process by using a larger cutter to remove large sections of the design. For small precise details of your image, use a small cutter. Attaching your plam carved stamps onto a wooden backing or employ Testament lock on that the Coat of arms prints evenly and cleanly, as it Testament be easier to operate compel to the back of a solid wood block than a Supple portion of rubber when printing the Coat of arms.
Instructions
1.5. Cut a piece of mounting foam sheet to the same size as the back of the stamp. One side of the foam mount is sticky, one side works through static cling. Peel off the cover on the sticky side of the mounting foam. Press the back of the stamp and the sticky side of the foam mount together.
6. Clean the wood block with a damp cloth. Leave to dry. Pull off the cover over the static cling side of the mounting foam. Press the static side of the foam onto the underside of the wood block. This creates a wooden handled stamp.
7. Press the stamp face down on a stamp pad. Print stamp in desired location on desired surface. Once you have finished printing, use an alcohol-free baby wipe to wipe the stamp clean.
