The several, elementary shape of a hammerhead shark makes it an prototype project for artists who are equal dawning to receive involved with working with clay. A hammerhead shark can be formed primarily with the hands and purified with a sculpting baggage or advantage blade. Regardless of your skill constant, adding a hammerhead shark to your clay organization can be enjoyable and won't lack a quota of eternity.
Instructions
1. Roll a group of clay to compose a cigar shape that tapers toward one limitation. This is your shark's target. Section two pieces of clay and shape them passion crescent moons.4. Form the hammer part of the hammerhead by cutting two rectangular shapes of clay and attaching one to each side of the body at the thickest end. Shape these with your thumb and forefinger to create the hammer.
2. Cut two triangular pieces of clay the same size as the tail fins and flatten them. Attach them near the front of the body with the pointed end of each piece facing out. These are the pectoral fins. Place two smaller fins about midway on the shark's body. They should be shaped like crescent moons and be about half the size of the pectoral and tail fins.
3. Cut a triangular piece of clay about as long as a pectoral fin and place it on top of the body, just an inch or two before the fattest part of the body. Again, the pointed edge should be facing out. Cut another triangular shape about half the size of a pectoral fin and place it on top of the body near the tail fins, with the pointed edge facing out.
Custom a overhaul scalpel or a clay sculpting effects with a Apartment lodgings metal line for this. Attach one quantity to Everyone side of the narrow edge of the oppose. These are the tail fins. The size of the tail fins depends upon the size of your shark, but for a shark model that is 6 inches long, the tail fins will be about 3 inches long. Put a small piece of clay on each end of the hammerhead for the eyes.
5. Cut a mouth just below the hammerhead. Remove a small piece of clay to form the mouth, then draw triangular teeth in the mouth with a toothpick. Etch the gills into the side of the shark's body with the toothpick as well. Three or four vertical lines just behind the mouth on each side of the shark will work for the gills.
