Home-made drum heads can commit you a cheap alternative to a store-bought instrument.
Drum heads can be fabricated Homewards with plastic sheeting for a fraction of the payment of the cognomen Trade-mark drum heads from your district drum mind dealer. A home-made drum head that is thicker or thinner than habitual Testament alternate the sound of that drum, too as the touch of playing that instrument. Your home-made drum mind may not sound as exceptional as a professionally constructed drum attitude, on the other hand plastic sheeting is one of the most coincident sounding alternatives.
Instructions
1. Loosen the tension rods on one side of the drum with the drum basic and remove tension rods from lugs. Country the tension rods well-organized and to the side.
2. Remove the drum hoop and levy to the side with the tension rods. You should have a four-layer, 12.5-inch by 12.5-inch square.5. Place this square on the drum shell, where the drum head would usually go.
This will allow you to make four layers for more durability.
4. Fold the plastic sheeting in half and then fold that half in half again. Loosen and remove the remaining tension rods and drum Tyre from the contrasted side of the drum.3. Reduce your plastic sheeting four times the drum calibre. Whether you are using an 11-inch tom, For instance, divide two pieces of plastic sheeting that degree 25 inches by 25 inches.
Put on the drum hoop over the plastic sheeting and hold the drum hoop on tight, keeping the plastic sheeting in place. Replace the tension rods and tighten.
6. Turn the drum over and repeat this process for the other side of the drum with your other piece of plastic sheeting. Keep the plastic as tight as you can while tightening the drum hoop with the tension rods. Repeat for the rest of your drums. Tune your drums to your liking using the drum key.
