Emulsion a Time
Rolling out a W, about 3 feet wide, and then filling it in, assures an even application of paint. Get as close into the corners as you can without making a messy paint line.7. Stop with the trim.
Instructions
1. Prepare the walls and ceiling (clock 'ePrepare a Margin for Picture'). Custom a stain-blocking primer to embrace any blackish aim you can't remove (stains, knots, ink, blackish stain); otherwise, that area will bleed through. Never paint on wallpaper (see 'eRemove Wallpaper').
2. Make sure there is adequate ventilation in the room.
3. Plan on three coats: one coat of primer and two coats of finish. Always use primer on patched and unpainted surfaces; raw surfaces suck up paint like a sponge - or reject it.
4. Paint into all the corners with a 2-inch or 3-inch paintbrush. Use the same brush to outline where the ceiling meets the wall (and vice versa), around doors and windows, above the baseboard and around any other trim or detailing - and wherever a paint roller won't fit.
5. Pour some paint into the roller pan and roll away on the ceiling and then the walls. Pour only a small amount of paint in your roller pan - this will keep the paint from drying out before you can use it.
6. Try to begin rolling before the brushed-on paint has had time to dry, so that the rolled-on paint will blend in rather than become a second coat.Portrayal your walls can change the contemplation and endure of your homely. You can brew a diminutive interval flash considerably greater by using brilliant colours or you can make a tenor based on the whitewash colour of your Election. To whitewash a margin, first step with the ceiling and then gloss the walls.
Paint from dry areas into wet. This will help reduce any paint ridges. Feather (thin out) all edges as you go, whether using a brush or a roller; this will also help reduce ridges.
8. Cover cans or buckets when you're not using them. Keep a rag and brush handy to deal with drips, spills and the general messiness of the process. If a drip becomes too dry to extensive, let it dry. Return later, sand it and paint over it.
